Home

What an MG Midget MkIV should sound like!

over 3k rpm) Custom 288° APT cam and lifters PRI 4-Keihin intake Custom Fisher damper/pulley Stock flywheel, lightened MSD Digital-6 ignition ...

Shelby GT500 Kenne Bell Dyno run 2nd try

Added innovators west overdrive damper pulley. As always, on pump gas. ... Shelby GT500 Kenne Bell Dyno run 2nd try ...

Texas Speedwerks Engine Damper

The Texas Speedwerks Version 2 Engine Damper. Installed on my 2005 MINI Cooper S. One Ball Exhaust, 15% Alta Pulley, Minspeed CAI.

Motorcycle Maintenance

Motorcycle application of the process to its increasingly technical in good condition and the assembly of the (component warranty) has a good performance, must be zero, to change parts and technical state of the law situation Dingqi Zuoye maintenance. Regular maintenance can be in one, split two, three-level maintenance.

1, a maintenance

If the vehicle a certain distance (typically 1000-2000 km Time) should be the provisions of parts lubrication, and tightening the car are screws, nuts. This type of lubrication, tightening the center is called a maintenance and repair. In addition to routine maintenance of the contents of a maintenance project, we have the following elements:

Motorcycle drive chain, should the chain be removed for cleaning, remove belt drive motorcycle, the pulley should be cleaned.

Clean carburetor, air filter, change fuel.

Remove spark plugs on the coke, review and adjust, and distance between the electrodes.

Check all cable connections are easily accessible.

Inspection, adjustment bypass the clutch, throttle handle, brake handle and pedal free travel, and the oil filling control lines.

Speedometer and tachometer on the flexible shaft with grease lubricated.

Oil change.

Second, two maintenance

To check and adjust the middle of the maintenance work is as a secondary supply. Motor Racing General should continue to be 3000-6000 km 2. In addition to a secondary content maintenance projects, maintenance work should be completed as follows:

Clear cylinder, cylinder head, pistons, piston rings and silencer on the coke.

to wear, check the clutch and brake shoes on the brake, depending on the situation of wear can be adjusted or replaced.

Check and adjust gap opener.

Check the before and after the wheels of the runout and concentricity of compliance requirements, such as excessive jumping, to be adjusted or replaced.

If you adjust the valve clearance.

Read more...